Hua Dui

Blog

2024.09.28

Ten steps in plastic mold design

Ten steps in plastic mold design

Usually, the mold design task book is proposed by the plastic part technician based on the task book of the molded plastic part, and the mold designer designs the mold based on the task book of the molded plastic part and the mold design task book.

2024-09-28

2024.09.28

The next era of lightweight automotive mold production has arrived

The next era of lightweight automotive mold production has arrived

At this stage, whether from the perspective of performance or environmental protection, lightweighting of automobile mold production has become an inevitable trend. Carbon fiber composite materials are the only choice for lightweighting automobiles. The well-known Formula One racing car body is made of carbon fiber composite materials as a whole. With the development of technology, this material has gradually become popular and has begun to be used in ordinary cars. The domestic Kangde Composite Materials Co., Ltd. has worked hand in hand with German researchers to develop and produce this technology, and has achieved certain results.

2024-09-28

2024.09.28

The market structure of stamping dies still needs to be adjusted and optimized

The market structure of stamping dies still needs to be adjusted and optimized

In recent years, the level of stamping dies in my country has been greatly improved. Large stamping dies can produce a single set of dies weighing more than 50 tons. And it can produce cover parts dies for mid-range cars. The domestic stamping die industry is constantly catching up with the world's advanced level and narrowing the technological gap with developed countries. Many domestic precision stamping dies can be compared with imported products in terms of main performance. However, most of my country's exported stamping dies are low-tech and low-end products. Therefore, the market satisfaction rate of high-tech dies is lower than the overall satisfaction rate of stamping dies. The development of these dies has lagged behind the production of stamping parts, and in some low-end simple dies, there is already an oversupply and fierce market competition.

2024-09-28

< 1 >